Belden GRASS VALLEY KMV-3901, Installation & Service Manual

Page: 89 / 128

89
KMV-3901/KMV-3911
Installation & Service Manual
10 Click OK .
The Apply settings button becomes available.
11 Click Apply settings .
The multiviewer must restart for changes to the network configuration to take effect. A
message appears prompting you to restart the system immediately.
12 Click OK .
Configuring the RCP-200
The RCP-200 is shipped with an IP address of 10.0.3.200. On installation, you should consult
your system administrator and replace this address with an appropriate address for your
local network configuration (see
Configuring the RCP-200’s IP settings on page 89). Once
your RCP-200 has an active connection to the network, you must then register the
multiviewers you want to operate from the RCP-200 (see
Specifying multiviewers for the
RCP-200 on page 90), and their respective KX Router logical routers (see Specifying lookup
servers for the RCP-200 on page 90). Once this is completed, you will be able to control the
monitor wall from the RCP-200 (see Logging on to the RCP-200 on page 90).
Configuring the RCP-200’s IP settings
To assign an IP address to the RCP-200
1 Press the CONFIG button, located between the two screens on the front of the RCP-200.
2 Touch the COMM category at the top of the right-hand screen.
3 Touch the ETHERNET tab on the right-hand screen.
4 In the SELECT area, rotate the leftmost control knob to select IP ADDRESS.
5 Use the four control knobs in the CHANGE area to set the new address.
The current address is displayed in the CURRENT box for reference, and the new
address you are setting appears in the MODIFIED box, as well as at the controls.
6 Press the SAVE control knob to store the new address.
Note:
Settings cannot be applied to a multiviewer system while an
upgrade is in progress. If the multiviewer does not restart after 10 seconds
or so, try clicking
Apply settings again after a minute or two.