KAYENNE K-FRAME — Installation & Service Manual
157
ClipStore Configuration
Configuring Source Definitions
To configure source definitions for ClipStore return outputs, choose a
source, a source type “Device”, an input fed by the device, a Key Mode, and
an Engineering Name for the source if desired.
The following example demonstrates the configuration of a Summit with
four ClipStore channels. In this example the physical BNC connections
from the ClipStore to the K-Frame are Inputs 25-32.
ClipStore can record Video only, Key only, or Video/Key clips. To do this,
both a video and a key for the video must be configured for each ClipStore
channel.
To configure a ClipStore source of a video/key pair as a video fill source:
1.
Go to the Eng Setup, Source Definition menu.
2.
From the Source List, touch a source.
3.
Use the default video input (Video In:) or change it using the
Video Input
data pad.
4.
Touch the Linear Key button to select it.
5.
Use the
Key Input
data pad (or soft knob) to select the source number of
the Key source you will use for the ClipStore channel.
6.
Configure the Source Type:
a.
Touch the
Device
mode button in the Source Type pane.
b.
Touch the
External Device
data pad, the External Device List is
displayed.
c.
Touch a CS channel to select it (
The External Device List closes and the Engineering Name is filled in
with the ClipStore External Device name automatically.
To configure a source as a ClipStore Key input (Key input to the ClipStore
Video input created earlier):
1.
From the Source List, touch a source (
2.
Touch the
No Key
button in the Key Mode pane to select it (if not
selected).
3.
Use the default video input (Video In:) or change it using the
Video Input
data pad.
4.
Touch the
Direct
mode button in the Source Type pane to select it.
5.
Give the ClipStore key input an Engineering Name if desired (CS-1K,
), by touching the
Engineering Name
data pad and entering the
name in the pop-up keyboard.
Summary of Contents for Grass Valley Kayenne K-Frame
