Belden Grass Valley Kaleido-X, Installation & Service Manual

Page: 23 / 216

23
Installation
This chapter provides information about system requirements, items shipped with your
Kaleido-X multiviewer and it will guide you through the installation of a Kaleido-X
multiviewer.
Getting Organized / Unpacking
Required Tools
Use a field-supplied Phillips #2 screwdriver to remove and install rear panels.
Required Materials
Make sure the following items have been shipped with your Kaleido-X. If any of these are
missing, contact your distributor or Grass Valley.
• Kaleido-X unit, with pre-installed cards and power supplies
• 2 AC power cords per power supply
• Kaleido Multiviewers Documentation Resource Guide.
• Keyboard
• Mouse
• Serial port adapters; one with straight cabling and one with crossover cabling for each
output card in your multiviewer (see also RS-422 Connection Diagram , on page 214):
• The Kaleido Multiviewers Documentation Resource Guide , which provides instructions on
how to access the documentation you need to install and use your new multiviewer.
See
Related Documentation
, on page 15
.
Part number Adapter cabling RS-422 pinout at the DE-9P connector
1737-3000-102 Straight Controller (SMPTE master) mode
1792-3700-100 Crossover Tributary (SMPTE slave) mode
Note:
In line with our commitment to environmental preservation, only the
Kaleido Multiviewers Documentation Resource Guide , and some related
documents (e.g., welcome letters, warranty cards) are distributed in printed
form. You can obtain the latest version of the Kaleido Software User’s Manual
and Installation & Service Manual for this multiviewer model, as well as the
Release Notes, from the
Documentation Library section of the Grass Valley
website. Software, drivers, and sample databases are available from the
Downloads section of the website.