112
Maintenance & Troubleshooting
Downgrading the Multiviewer System
Downgrading the Multiviewer System
To downgrade your multiviewer to an earlier version of Kaleido Software
• When the multiviewer is running Kaleido Software version 10.XX or lower, follow the
upgrade instructions in the Release Notes that were published for the Kaleido Software
version you want to downgrade to.
• When the multiviewer is running Kaleido Software version 11.0.0 or higher and you
want to downgrade it to Kaleido Software version 10.XX or lower, refer to the
Migration
to Version 11 or Higher Upgrade Guide
for more information about how to do this. See
, on page 15. This is only available if the multiviewer had
previously run Kaleido Software version 10.XX or lower and was upgraded according to
the
Migration to Version 11 or Higher Upgrade Guide
.
• When the multiviewer is running Kaleido Software version 11.0.0 or higher and you
want to upgrade or downgrade it to another Kaleido Software version 11.0.0 or higher,
Upgrading and Downgrading a Multiviewer Running Kaleido Software Version
IMPORTANT
The Kaleido
-
IP X320 and X120 multiviewers cannot be downgraded to a
version earlier than 8.60.
Summary of Contents for GRASS VALLEY KALEIDO Series
