Belden Grass Valley KALEIDO-IP X110, Installation & Service Manual

Page: 106 / 110

106
Specifications
The following table lists some (but not all) output formats supported at the DisplayPort
connections.
You can customize your own timing rates for resolutions ranging from 1280 × 1024 pixels
up to 1920 × 1200 pixels (all progressive scan), by using XEdit.
Decoding Capacity
Numbers represent the maximum video decoding capacity when only this format is used
and head streaming is disabled. Actual performance may vary according to the content’s
complexity. This table and accompanying notes should only be used as general guidelines.
The absolute maximum video decoding capacity is 128 streams under all conditions. Audio
decoding capacity is limited only by processor usage.
• If one head streaming is enabled, decoding capacity is reduced by 4%. If two head
streaming is enabled, decoding capacity is reduced by 8%.
• Halving the bit rate increases the decoding capacity by approximately 33%. Doubling
the bit rate decreases the decoding capacity by approximately 25%.
• Using H.265 with Main profile instead of Main10 increases the decoding capacity by
approximately 25%.
• Using 4:2:2 instead of 4:2:0 will decrease the decoding capacity. Benchmark results are
not yet available for 4:2:2.
Video codec decoding capacity
Kaleido-IP HDMI output formats
Resolution Format name Refresh rates (Hz)
1280 × 1024 SXGA 50, 59.94
1280 × 1024 BARCO 59.94
1360 × 768 NEC 50, 59.94
1480 × 1200 Christie 50, 59.94
1600 × 1200 UXGA 50, 59.94
1920 × 1080 Baycat 50, 59.94
1920 × 1200 WUXGA 50, 59.94
Note: After configuring custom resolutions in XEdit, you must restart the
Kaleido-IP for the new resolutions to become effective.
Codec
→
Model
↓
MPEG-2
SD Main,
8 Mb/s
MPEG-2
HD Main,
20 Mb/s
H.264
SD High,
2 Mb/s
H.264
HD High,
10 MB/s
H.265 SD
Main10,
2 Mb/s
H.265 HD
Main10,
5 Mbps
H.265
1080p50/59
Main10,
5 Mbps
H.265 4K
Main10,
25 Mb/s
Main Tier
H.265 4K
Main10,
125 Mb/s
High Tier
X110 48 16 24 12 20
X310 128 64 100 24 84 20 12 2 1