GUIDE TO INSTALLATION AND OPERATION
HDA-1941/51 & HDA-3941/51 |
13
2.
The center portion of the iControl graphic interface window contains a series of control and information panels,
selected by tabs.
•
Click on a tab to display the associated panel.
•
Each of these panels is described individually in the following sections.
3.
The Load Factory button is always visible at the bottom of the panel. Click the
Load Factory
button to reset all
parameters on this HDA card to factory default values.
•
The factory default values are shown underlined in the menus found in the Annex to this document, beginning
on page 20.
3.4.2 The Status panel
This panel shows the status of the inputs to this HDA.
For HDA-1941 and HDA-3941, only IN A is shown, because there is no IN B,
Input Status (A and B)
Data rate (270 Mbps / 1.5 Gbps / 3 Gbps) – the detected input data rate is
indicated by a green status icon
No Lock / No Signal – either of these conditions is indicated by a red status icon
3.4.3 The Input panel
This panel allows the user to set the reclocker
status on the input channel(s).
Reclocker
Use the radio buttons to independently turn the
reclockers for Channels A and B ON or OFF
Figure 3.3 Input panels – HDA-1941 (left) and HDA-3951 (right)
Figure 3.4 Status panel
