54
Configuring Your GV Node
Input Configuration - SDI
To choose the color for the RGB value
1 Click the color patch in the screen beside the Output on Error Mode pulldown.
The Color Selection window opens.
2 Click
Default
to select and apply the default color (Black: Y=16; Cb=Cr=128)
3 Move the sliders, or type into the data boxes, to adjust the color.
Invalid colors will be flagged as
Invalid RGB
beneath the color patch in this window,
and inside the color patch in the SDI IN window.
4 Click
Apply
to confirm your changes, or
Cancel
to leave the color unchanged.
To select the Output on Error for all nine SDI Inputs at once
1 Click
Input Config
and select the
All
tab.
2 Click on the
Output on Error Mode
pulldown.
3 Click to select the desired output from the XIO-4901 to the IFM-2T when the SDI input
is in error.
Output
Details
Blank
Use the selections made on the 9 individual Input tabs.
Color bar
Feed a standard color bar signal to the fabric module.
RGB value
Feed a full-frame color patch to the fabric module.
4 You must select the color patch individually for each of the nine outputs, as per
choose the color for the RGB value
, on page 54. You can use the color patches here
instead of returning to the individual tabs - they are interconnected.
