Belden Grass Valley GV Korona, User Manual

Page: 367 / 433

367
Kayenne/Karrera/GV Korona
User Manual
2 Click on the New Auth Code for Perm data field.
3 Enter the authorization license code.
4 Select Replace or Install. The authorization code will be added.
5 If necessary, using the procedure above, enable your Image Store Cache size. A
minimum of 32GB is recommended to maximize your movie storage time.
Movie Playback from the Menu Application
Movies that have been loaded to Image Stores can be cued and played from any of the
Image Store Images tabs (Stills, Movies, Movie Record, Movie Edit). When an Image Store
channel with a loaded movie is selected, the Cue to Start, Play Reverse, Stop, Play Forward,
and Cue to End buttons are activated, and the progress bar above them indicates the
current location of the movie.
Movie Cue and Playback Controls
Once a movie is loaded and selected for control, the Cue to Start, Play Reverse, Stop, Play
Forward, and Cue to End buttons are available. Additional menu playback controls include:
• Loop —Sets the movie to run continuously, jumping from its last frame to the first.
• Bounce —Sets the movie to run to its end, reverse playback to its beginning, then play
forward, and repeat (only available when Loop is active).
• Auto Start —Sets the movie to play when taken On-Air.
• KF Trigs — Enables EMEM KF triggering (see E-MEM Keyframe Triggers for Image Store
Movies , on page 368).
• Timecode —Opens a keypad allowing entry of a time code value to cue the movie to.
This control is also available on the Movie Record and Movie Edit menus.
• Mark In —Sets the current cued location of the movie as its playback start point.
• Mark Out — Sets the current location of the movie as its playback end point.
• Cue to Begin — Cues to the Mark In point, if set.
• Var Play Speed — When On, plays the clip at the percentage speed displayed on the
right. Clicking on the percentage allows entry of the desired speed. Supported range is
from 0.1% to 5000%.
• Jog Movie —The knob on the Menu Panel can be used to jog the movie forwards and
backwards. This control is also available on the Movie Record and Movie Edit menus.
Movie Playback with the System Bar
Selecting an Image Store channel on the PVW bus activates the System Bar controls, which
will display the currently loaded item. The System Bar Cue/Load, Play, Previous, and Next
buttons allow the loading, cuing and playback of movies on that Image Store channel.
If a Image Store channel is selected on the PGM bus, holding down that source select
button activates the System Bar for control of that Image Store channel.
Note: A minimum of 16GB of Image Store Cache must be enabled.