PX106545-EN, Rev.A
4
Warnings
Use proper power voltage.
AC power for the charger is AC100-240V, 50~60 Hz.
Test the AC power before use. When the output voltage of AC power is high,
or abnormal frequency is generated, the product is damaged; serious injury or
even death may result.
AC output voltage should be measured using a circuit tester before
connecting the AC power cable; regular inspection should also be conducted.
Do not pull the AC power cord with excessive force, apply heat or
transform it. When a damaged power cord is used, it may cause fire or
injury.
Use a three-plug AC power cord. Never use a two-plug power cord, cable or
plug.
Do not touch the AC plug, AC power cord or splicer with wet hands. It
may cause electrical shock.
Do not disassemble the AC charger, battery or FX Fusion Splicer.
Deformation may cause fire, electrical shock or injury.
Refer to the following when using the battery:
Failure to use batteries and chargers provided by Belden may result in
smoke, equipment damage, burn, injury or even death.
Do not incinerate any conductive materials.
Do not charge the battery near flame.
Do not give an excessive shock to the battery.
When the battery does not completely charge in two hours, or when the
green LED is not turned on, stop charging immediately and contact Belden.
Do not put anything on the AC charger while charging.
Use only the AC charger provided. Do not use another AC power cord or
battery. Excessive current may result in equipment damage or injury.
Do not use the FX Fusion Splicer where there is harmful gas or flammable
liquid. Explosion or fire may result.
