FX FUSION LC CONNECTOR
PX106498-EN REV C
Page 6 of 8
900µm TIGHT BUFFER/250µm - INSTALLATION GUIDE
12.
Place the cleaved fiber in the
V-groove (on the right
side
) of
the fusion splicer.
NOTE:
The placement of the end face is
important. Fibers end face should
be located in between the V-groove
and electrodes as shown.
13.
Perform the fusion.
14.
Bring the splice
protection
sleeve
with the
spring
close to
the splicer.
15.
Open the splice holder and, by
holding the cable and the
dust
cap
, remove the spliced cable
assembly from the splicer.
