9
ASSEMBLY
Step 1. Support frame a few feet above floor
with blocks or a Tar River Implement han-
dler.
DRL
-
072
Align the double disc openers to the proper
7”
spacing. It is easier to begin mounting the
U bolts that hold the Double Disc Assembly
on one end and align the next one on the
same bar
14”
beside it. The Double Disc As-
semblies mounted on the back bar should
begin between the front. There will be 5 on
each bar.
DRL
-
048
Align the center rear Double Disc opener of
the machine using the 3pt. Support as a
guide. Then slide the two front middle ones
as far left and right as possible as in picture.
Then use these to adjust the remaining
14”
on center. There will be 4 on the front bar
and 3 on the rear.
Step 2. Mount hopper box with the lid
opening towards the front. DO NOT
TIGHTEN BOLTS AT THIS STEP
14”
7”
7”
