INSTALLATION MANUAL
1. Electric Drill
2. Drill Bit
(2.3mm or 3mm)
3. Phillips Screwdriver
4. Router and Grinder
(cutting-edge 3mm)
5. Round File
6. Masking Tape
Masking
Tape
Masking
Tape
1. Preamp
2. Battery
Box
3. Pick-Up
4. Clip
8. Fix wire with clip
.
5. Screw
1. Contents
2. Tool
2.Drilling hole for pick-up
3. Insert EQ and battery box into hole of guitar
.
1. Cut out the hole with template
4. Fasten screws properly
.
5. Put plugs
into jacks
.
6.Installing the pick-up
Cutting
Template
Cutting
Template
1) When there is no sound or sound is stopped,
- Check guitar cable, amp or Mixer
- Check if there is batter or not. When it happens noise or distortion,
please exchange battery.
- Check if the pickup and battery connector is connected correctly
or not.
- Check if out put jack is connected correctly.
2) When there is hum-noise,
- Check the pickup is connected well or not.
- Check if the connectors are connected to correct position well
or not.
3) Some causes of the balance problem
- When the bottom of saddle or the groove of saddle is not flat.
- When saddle is installed to the groove of saddle loosly.
- When the connection is not good between the bottom of saddle
and the groove of saddle.
- When Saddle is very short
- When there is grounds on the groove of saddle.
- When Saddle is declined toward front or back.
- When the top of guitar is bended.
- When the pickup is installed to only a part of the groove of saddle.
Solution
Pick-up
Wire
Clip
EQ
Battery box
Cable
Battery
Box
Pick-up
wire
(
back page)
Preamp
Battery Box
D
C
B
A
G
F
E
#
Chromatic Tuner
BASS
MIDDLE
TREBLE
BRIGHT
MIDDLE FREQ.
NOTCH
VOLUME
TUNER
Low
Batt.
PHASE
