BelAir Networks BelAir 100SN, User Manual

Page: 95 / 212

BelAir100SN User Guide Configuring Wi-Fi Access Point Parameters
May 31, 2010 Confidential Page 95 of 212
Document Number BDTM11001-A01 Released
By default, SSID 8:
• uses WPA encryption with the following pre-shared key:
DefaultKey123
.
Users may wish to change the security settings to suit their needs.
• is not mapped to a VLAN. Users may wish to map SSID 8 to a separate
VLAN reserved for management sessions.
Refer to the following topics for details on changing the default settings for
SSID 8:
• To change the SSID and map it to a VLAN, see “Configuring SSIDs” on
page 95 .
• To change the security settings, see “Wi-Fi AP Security” on page 99 .
Configuring SSIDs
/interface/wifi-<n>-<m>/set ssid <ssid_index>
service-set-identifier <ssid_string>
{broadcast | suppressed}
vlan {<vlanID-list>|none}
This command allows you to configure AP SSIDs.
The
ssid_string
parameter is the SSID setting. SSIDs are case sensitive and can
contain up to 32 alphanumeric characters.
The
ssid_index
parameter is an integer from 1 to 8. Use the
show ssid table
command to determine
<ssid_index>
.
For a description of the
broadcast
and
suppressed
parameters, see “Displaying
the SSID Table” on page 93 .
The
vlanID-list
parameter, if present, specifies a comma separated list of VLAN
IDs. Each VLAN ID must be an integer from 1 to 2814. The list can contain up
to eight VLAN IDs.
The
vlanID-list
parameter activates functionality to balance traffic among up to
eight VLANs, based on the last three bits of the MAC address of the wireless
client generating the traffic. The last three bits of the MAC address can range in
value from 0 to 7. For example:
• Traffic from clients where the last three bits have a value of 0 is directed to
the first VLAN on the list.
• Traffic from clients where the last three bits have a value of 1 is directed to
the second VLAN on the list.