BEL STEWART 298007X-01 CRIMP TOOL Complete with dies
From MN290008 Rev A3
2.
Terminating procedure
Assemble plug onto cable according to manufacturer instructions.
IMPORTANT:
Prior to crimping, close the shield wings by
hand. Width of shield wings shouldn’t exceed 13 mm (Fig.2).
Figure 2
Insert the plug assembly in the tool as shown (Fig.3).
Clicking sound of the plugs' locking tab is the end of inserting process.
Slowly close tool handles completely
to perform full cycle crimping. (Fig.4.)
NOTE: In case the tool becomes blocked
for any reason, follow unblocking
procedure Item 3. on the next page of this
document.
Figure 3
Figure 4
After the full crimping cycle is done, open the tool fully in order to remove
crimped plug.
Press release button (A) (Fig.5 &
6.) at the back side of the tool
and pull out the plug assembly.
The tool is ready for next
crimping cycle.
Figure 5
Figure 6
