LDP200-200
4
FIG.4 - MOUNTING / DISMOUNTING INSTRUCTIONS
For DIN rail fastening according to IEC 60715 TH35-7.5(-15)
Mounting as shown in figure, with input terminals on lower side, with suitable cooling and maintaining a proper distance between adjacent devices as specified in the
Installation Instruction of each family.
MOUNTING:
1.
Tilt the unit slightly backwards.
2.
Fit the unit over the top edge of the rail.
3.
Slide it downward until it hits the stop.
4.
Press against the bottom for locking.
1
2
3
4
DISMOUNTING:
1.
Pull down the slide clamp lever
2.
Tilt the unit upward
3.
Unhook the unit from the rail
1 & 2
3
FIG.5 - RECOMMENDED CONNECTING CABLE
Recommended Tightening torque
0.5 - 0.6 Nm
4.42 - 5.30 lbf in
Solid: 2.5 mm² / 12 AWG
Stranded:1.5 mm² / 12 AWG
L: 6.0 - 7.5 mm / 0.24 - 0.30 in
FIG.6 - INPUT PROTECTION
Fuse MCB 6 A C curve or 4 A D curve.
For USA and Canada, use the fuse type closest to the European equivalent type.
Surge protection:
it is strongly recommended to provide external surge arresters (SPD) according to local regulations.
