IMPORTANT
INSTALLATION INSTRUCTIONS
1.
The space in the room where the appliance is installed must not be smaller
than 10 cubic metres.
2.
If possible avoid placing the appliance near cookers, radiators or in direct
sunlight as this will cause the compressor to run for long periods. If installed
next to a source of heat or refrigerator, maintain the following minimum side
clearances:
From Cookers
2" (50 mm)
From Radiators
12" (300 mm)
From Refrigerators or Larder Fridge 1" (25 mm)
3.
No gap is required at sides and top. See item 4 below to ensure a gap is
obtained at the rear of the appliance. If a gap is available on side and top,
retain it if possible as it would improve the air circulation around the appliance.
4.
Fit the two plastic wall spacer supplied
with the appliance rotating 1/4 turn to
the condenser at the back of the
refrigerator (see diagram).
5.
The appliance should be located on a
smooth surface. The two front feet can be
adjusted as required. To ensure that,
your appliance is standing upright adjust
the two front feet by turning clockwise or
anti-clockwise, until the product is in
firm contact with the floor. Correct adjustment of feet avoids excessive
vibration and noise.
6.
Refer to "Cleaning and Care" section to prepare your appliance for use.
7.
Thermostat is located on the rear wall of the cabinet (See above diagram) and
controlled by the thermostat knob. (See diagram on page 9)
5
TRANSPORTATION INSTRUCTIONS
1.
The appliance should be transported only in a vertical upright position. The
packing as supplied must be intact during transportation.
2.
If during the course of transport the appliance has to be transported horizontally,
it must only be laid on its left hand side when standing in the front of the
appliance. After bringing it to upright position,it must not be operated for at
least 4 hours to allow the system to settle.
3.
Failure to comply with the above instructions could result in damage occuring
to the appliance. The manufacturer will not be held responsible if these
instructions are disregarded.
4.
The appliance must be protected against rain, moisture and other
atmospheric influences.
5.
When positioning your appliance take care not to damage your flooring,
pipes, wall coverings etc. Do not move the appliance by pulling by the door
or handle.
IMPORTANT :
Care must be taken while cleaning / carrying the appliance to
avoid touching the bottom of the condenser metal support or pipework at the
back of the appliance as you might injure your fingers and hands or damage
your product.
IMPORTANT :
This appliance is not designed for stacking with any other
appliance.
Do not attempt to sit or stand on top of your appliance as it is not designed for
such use. You could injure yourself or damage the appliance.
IMPORTANT :
Make sure that mains cable is not caught under the appliance
during and after carrying / moving the appliance, to avoid the mains cable
becoming cut or damaged.
Do not allow children to play with the appliance or tamper with the controls.
Take care when installing your appliance and using it for the first time, during
normal daily use, while defrosting and cleaning the interior freezer compartments
not to damage cold panels and pipes and to avoid any injury. We recommend the
use of a pair of gloves when cleaning the cold panels as you might injure your
fingers and hands and/or damage the appliance beyond repair.
BEKO plc declines to accept any liability should the instructions not be
followed.
4
Thermostat
A special receptacle is supplied to store the mains plug during transit.
The receptacle is fixed at the back of the
cabinet, on the right hand side of the
compressor. (See diagram) Gently remove
the plug from the receptacle. Never pull
the mains cord, you may damage the
appliance. In the case of transportation,
ensure you locate the plug in the receptacle
provided to avoid transit damage.
8.
OFF
