Beko WMY 71432LMB3, User Manual

Page: 77 / 84

77 / EN
Washing Machine / User’s Manual
After every washing make sure that no foreign
substance is left in the drum.
If the holes on the bellow shown in the figure is blocked,
open the holes using a toothpick.
C
nOTE :
Foreign metal substances will cause rust stains
in the drum. Clean the stains on the drum surface by
using cleaning agents for stainless steel. Never use steel
wool or wire wool.
A
CAUTIOn :
Never use sponge or scrub materials. These
will damage the painted and plastic surfaces.
5.3 cleaning the body and control panel
Wipe the body of the machine with soapy water or non-
corrosive mild gel detergents as necessary, and dry with a
soft cloth.
Use only a soft and damp cloth to clean the control panel.
5.4 cleaning the water intake filters
There is a filter at the end of each water intake valve at the
rear of the machine and also at the end of each water intake
hose where they are connected to the tap. These filters
prevent foreign substances and dirt in the water to enter the
washing machine. Filters should be cleaned as they do get
dirty.
1. Close the taps.
2. Remove the nuts of the water intake hoses to access
the filters on the water intake valves. Clean them with an
appropriate brush. If the filters are too dirty, take them out
by means of pliers and clean them.
3. Take out the filters on the flat ends of the water intake
hoses together with the gaskets and clean thoroughly
under running water.
4. Replace the gaskets and filters carefully in their places
and tighten the hose nuts by hand.
5.5 Draining remaining water and cleaning the
pump filter
The filter system in your machine prevents solid items
such as buttons, coins and fabric fibers clogging the pump
impeller during discharge of washing water. Thus, the water
will be discharged without any problem and the service life
of the pump will extend.
If the machine fails to drain water, the pump filter is clogged.
Filter must be cleaned whenever it is clogged or in every 3
months. Water must be drained off first to clean the pump
filter.
In addition, prior to transporting the machine (e.g., when
moving to another house) and in case of freezing of the
water, water may have to be drained completely.
A
CAUTIOn :
Foreign substances left in the pump filter
may damage your machine or may cause noise problem.
In order to clean the dirty filter and discharge the
water:
1. Unplug the machine to cut off the supply power.
A
CAUTIOn:
Temperature of the water inside the
machine may rise up to 90 ºC. To avoid burning risk, filter
must be cleaned after the water in the machine cools
down.
2. Open the filter cap.
If the filter cap is composed of two pieces, press the
tab on the filter cap downwards and pull the piece out
towards yourself.
If the filter cap is one piece, pull the cap from both
sides at the top to open.
C
nOTE :
You can remove the filter cover by slightly
pushing downwards with a thin plastic tipped tool,
through the gap above the filter cover. Do not use metal
tipped tools to remove the cover.