39
EN
3
Installation
Refer to the nearest Authorised Service
Agent for installation of the product. To
make the product ready for use, review
the information in the user manual and
make sure that the electricity, tap water
supply and water drainage systems are
appropriate before calling the Authorized
Service Agent. If they are not, call a
qualified technician and plumber to have
any necessary arrangements carried out.
C
Preparation of the location and
electrical, tap water and waste water
installations at the place of installation is
under customer's responsibility.
B
Installation and electrical connections
of the product must be carried out
by the Authorized Service Agent.
Manufacturer shall not be held liable
for damages that may arise from
procedures carried out by unauthorized
persons.
A
Prior to installation, visually check if
the product has any defects on it. If
so, do not have it installed. Damaged
products cause risks for your safety.
C
Make sure that the water inlet and
discharge hoses as well as the power
cable are not folded, pinched or
crushed while pushing the product into
its place after installation or cleaning
procedures.
Appropriate installation location
• Place the machine on a rigid floor. Do
not place it on a long pile rug or similar
surfaces.
• Total weight of the washing machine
and the dryer -with full load- when
they are placed on top of each other
reaches to approx. 180 kilograms.
Place the product on a solid and flat
floor that has sufficient load carrying
capacity!
• Do not place the product on the power
cable.
• Do not install the product at places
where temperature may fall below 0ºC.
• Place the product at least 1 cm away
from the edges of other furniture.
Removing packaging
reinforcement
Tilt the machine backwards to remove
the packaging reinforcement. Remove the
packaging reinforcement by pulling the
ribbon.
Removing the
transportation locks
A
Do not remove the transportation
locks before taking out the packaging
reinforcement.
A
Remove the transportation safety
bolts before operating the washing
machine, otherwise, the product will be
damaged.
1. Loosen all the bolts with a spanner until
they rotate freely (C).
2. Remove transportation safety bolts by
turning them gently.
3. Attach the plastic covers supplied in
the User Manual bag into the holes on
the rear panel. (P)
Summary of Contents for WMB 51232 PT
Page 1: ...Masina de spalat automata Washing Machine WMB 51232 PT ...
Page 32: ......
