Beko WM 6103 W, Installation & Operating Instructions Manual

Page: 34 / 40

34
EN
Laundry remains wet at the end of the programme
• Excessive foam might have occurred and automatic foam absorption system might
have been activated due to too much detergent usage. >>> Use recommended
amount of detergent.
C
Machine does not switch to spinning step when the laundry is not evenly
distributed in the drum to prevent any damage to the machine and to its
surrounding environment. Laundry should be rearranged and re-spun.
A
If you cannot eliminate the problem although you follow the instructions in this section,
consult your dealer or the Authorized Service Agent. Never try to repair a nonfunctional
product yourself.
Machine does not start. Nothing appears on the display.
Machine may be unplugged. >>> Check the plug and attach it to the socket.
Fuse may be defective. >>> Check the fuse and have it replaced by a qualified
electrician if necessary.
Power may be out. >>>
Check if there is any power outage.
On / Off button might not be pressed. >>> Press On / Off button.
Machine does not start when Start / Pause / Cancel button is pressed after selecting
the programme.
Loading door may be open. >>>
Close the loading door.
Rinse symbol flashes in the display. (No Water symbol may also be lit depending on
the model of your machine).
Water may be cut off. >>>
Make sure that the water is not cut off and press Start /
Pause / Cancel button again to start your machine.