EN
8
is blinking either there is no water or tap is off. Check
your taps. Turn your machine off and on. If the prob-
lem persists unplug your machine, turn off tap water
and call authorized service.
• If program is started and program selection can not be
performed your machine might be in protection mode
due to infrastructure problem (voltage, water pressure,
etc.) Press and hold the > Start/Pause/Cancel < but-
ton for 3 seconds in order to switch machine to factory
settings.
• Most of the warnings resulting in calling an authorized
service are due to infrastructure problems. For this
reason applying to an Authorized Service is recom-
mended.