Beko TLDA 567 Installation, Operation & Food Storage Instructions Download Page 3

ELECTRICAL REQUIREMENTS

Before you insert the plug into the wall socket make sure that the voltage and the
frequency shown in the rating plate inside the appliance corresponds to your

electricity supply. Rating plate is affixed on the left hand side of inner liner
We recommend that this appliance is connected to the mains supply via a

suitable switched and fused socket. The appliance must be positioned so that the

plug is accessible.
Should the mains lead of the appliance become damaged or should it need
replacing at any time, it must be replaced by a special purpose made mains lead

which can only be obtained from a BEKO Authorised Service Agent.

WARNING! THIS APPLIANCE MUST BE EARTHED

If the fitted moulded plug is not suitable for your socket, then the plug should be

cut off and an appropriate plug fitted. Destroy the old plug which is cut off as a
plug with bared cord could cause a shock hazard if inserted into a socket
elsewhere in the house.

The moulded plug on this appliance incorporates a 13 A fuse. Should the fuse
need to be replaced an ASTA approved BS 1362 fuse of the same rating must be

used. Do not forget to refit the fuse cover. In the event of losing the fuse cover the
plug must not be used until a replacement fuse cover has been fitted. Colour of
the replacement fuse cover must be the same colour as that visible on the pin face

of the plug. Fuse covers are available from any good electrical store.

IMPORTANT! FITTING A DIFFERENT PLUG

As the colours of the wires in the

mains lead of this appliance may
not correspond with the coloured
markings identifying the terminals

in your plug proceed as follows:
(See diagram).

1. 

Connect the green-yellow or

    green (Earth) wire to the terminal
    in the plug marked 'E' or with

    the symbol           or coloured

    green and yellow or green.

2. 

Connect the blue (Neutral) wire

    to the terminal in the plug
    marked 'N' or coloured black.

3.

 Connect the brown (Live) wire to

    the terminal in the plug marked 'L'
    or coloured red.
With alternative plugs a 13 A fuse must be fitted either in the plug or adaptor or

in the main fuse box.
If in doubt contact a qualified electrician.

FITTED WITH

BS 1362 13A FUSE ALWAYS

FIT BS 1362 REPLACEMENT

CARTRIDGE FUSE

GREEN &

YELLOW

OR

GREEN

N

BLUE

OR

BLACK

L

BROWN

OR

RED

22mm.

6mm.

6mm.

6mm.

32mm.

12mm.

FUSE

CORD GRIP

TRANSPORTATION INSTRUCTIONS
1.

The appliance should be transported only in a vertical upright position. The
packing as supplied must be intact during transportation.

2.

If during the course of transport the appliance has to be transported horizontally,
the product must only be laid on its left hand side (when facing the door 
front) and it must not be operated for at least 4 hours to allow the system to 
settle after the appliance is brought back to upright position.

3.

Failure to comply with the above instructions could result in damage occurring.
to the appliance. The manufacturer will not be held responsible if these
instructions are disregarded.

4.

The appliance must be protected against rain, moisture and other
atmospheric influences.

5.

When positioning your appliance take care not to damage your flooring, 
pipes, wall coverings etc. Do not move the appliance by pulling by the door 
or handle.

6. 

Empty any water in the drain tray before moving. See section ‘Defrosting’ and

    ‘Care & cleaning’ for further information.

IMPORTANT :

 Care must be taken while cleaning / carrying the appliance to

avoid touching the bottom of the condenser metal wires at the back of the
appliance as you might injure your fingers and hands.

IMPORTANT :

 This appliance is not designed for stacking with any other

appliance.
Do not attempt to sit or stand on top of your appliance as it is not designed for
such use. You could injure yourself or damage the appliance.

"IMPORTANT:

 Make sure that mains cable is not caught under the appliance

during and after carrying / moving the appliance, to avoid the mains cable
becoming cut or damaged."

Do not allow children to play with the appliance or tamper with the controls.
BEKO plc declines to accept any liability should the instructions not be
followed.
           

4

3

Summary of Contents for TLDA 567











Reviews: