Beko SWRE 7512 XWW2, User Manual

Page: 16 / 44

16 / EN
Washing Machine / User’s Manual
You can also change the speed and temperature settings. See, "Spin speed selection" and "Temperature
selection".
C
If no change is allowed, the relevant light will flash 3 times.
Adding or taking out laundry
1. Press Start / Pause button to switch the machine to pause mode. The programme follow-up light of the
relevant step during which the machine was switched into the pause mode will flash.
2. Wait until the Loading Door can be opened.
3. Open the Loading Door and add or take out the laundry.
4. Close the Loading Door.
5. Make changes in auxiliary functions, temperature and speed settings if necessary.
6. Press Start / Pause button to start the machine.
4.16 Cancelling the programme
To cancel the programme, turn the Programme Selection knob to select another programme. Previous
programme will be cancelled. End / Cancel light will flash continuously to notify that the programme has
been canceled.
Your machine will end the programme when you turn the Programme Selection knob; however, it does not
drain the water inside. When you select and start a new programme, the newly selected programme will
start depending on the step the previous programme was canceled in. For example, it may take in additional
water or continue to wash with the water inside.
C
Depending on the step where the programme was canceled in, you may have to put detergent and softener again for the
programme you have selected anew.
4.17 End of programme
“End” appears on the display at the end of the programme.
1. Wait until the loading door light illuminates steadily.
2. Press On / Off button to switch off the machine.
3. Take out your laundry and close the loading door. Your machine is ready for the next washing cycle.
4.18 Your machine features "Standby Mode".
After you switch on your machine with On-Off button, if no programme is started or no other procedure is
performed at the selection step or no action is taken within approx. 2 minutes after the selected programme
ends, your machine will switch to energy saving mode automatically. The brightness of the indicator lights
will decrease. Also, if your product has a display that shows programme time, this display will be completely
turned off. If you turn the Programme Selection knob or touch any button, lights and display will switch back
to previous condition. The selections which you make when exiting from the energy efficiency may change.
Please check the correctness of your selections before starting the programme. If necessary, please make
your settings again. This is not an error.
5 Maintenance and cleaning
Service life of the product extends and frequently faced problems decrease if cleaned at regular intervals.
5.1 Cleaning the detergent drawer
Clean the detergent drawer at regular intervals (every 4-5 washing cycles)
as shown below in order to prevent accumulation of powder detergent in
time.
Lift the rear part of the siphon to remove it as illustrated.
C
If more than normal amount of water and softener mixture starts to gather in the softener compartment,
clean the siphon.
2 Wash the detergent drawer and the siphon with plenty of lukewarm water in a washbasin. Wear
protective gloves or use an appropriate brush to avoid touching of the residues in the drawer with
your skin when cleaning.
3 After cleaning, replace the siphon back to its seating and push its front section downwards to make
sure that the locking tab engages.