Electric connection
Your appliance is intended to operate at a
single-phase voltage of 230V/50 Hz. Before
plugging in the appliance, please make sure
that the parameters of the mains in your
house (voltage, current type, frequency)
comply to the operation parameters of the
appliance.
The information concerning the supply
voltage and the absorbed power is given on
the marking label placed in the back side of
the appliance.
The electric installation must comply with
the law requirements.
The earthing of the appliance is
compulsory. The manufacturer has no
responsibility for any damage to persons,
animals or goods which may arise from
the failure to observe the specified
conditions.
The appliance is endowed with a supply
cord and a plug (European type, marked
10/16A) with double earthing contact for
safety. If the socket is not the same type with
the plug, please ask a specialised electrician
to change it.
Do not use extension pieces or multiple
adapters.
The appliance is not built to be included into
the furniture.
Please fit the supplied accessories.
Switching off
The switching off must be possible by taking
the plug out of the socket or by means of a
mains two-poles switch placed before the
socket.
Operation
Before putting into operation, clean the inside
of the appliance (see chapter „Cleaning").
After finishing this operation please plug in the
appliance and switch on.
The green and red LEDs in the signalling
block must light.
Leave the appliance work for about 2 hours
without putting food inside it.
3
EN
Instruction for use
If your appliance has a lock, keep it locked
and store the key in a safe place, out of the
reach of children. If you are discarding an
appliance with lock, make sure that, is made
ineffective. This is very important so as to
avoid children being trapped inside, which
may cause their loss of life.
Do not block the gap between the floor and
the appliance bottom, as the unit must be
ventilated.
Do not place any objects immediately next
to the outer housing of the appliance. There
must be a distance of at least 50mm around in
order to ensure heat exchange (Item2).
When plugging the freezer the outer
housing temperature may become very warm
for a period of 1-2 hours.
Setting up
This appliance was designed to operate at an
ambient temperature b10°C and
+40°C. If the ambient temperature is above
+40°C, inside the appliance the temperature
can increase.
Set up the appliance far from any source of
heat and fire. Placing it in a warm room, the
direct exposure to sunbeams or near a heat
source (heaters, cookers, ovens), will
increase the energy consumption and shorten
the product life.
Please observe the following minimun
distances:
100 cm from the cookers working with
coal or oil;
150 cm from the electric and gas
cookers.
Ensure the free circulation of the air around
the appliance.
Place the appliance in a perfectly even, dry
and well ventilated place.
Assemble the supplied accessories.
