EN
If the ambient temperature is below
0°C, the food in the fridge will freeze.
So, we recommend you don’t use the
appliance in such low ambient
conditions.
2. Do not place the appliance near
cookers, radiators or in direct sunlight
as this will cause your appliance to
work harder. If installed next to a
source of heat or freezer, maintain the
following minimum side clearances:
From Cookers 50 mm (2”)
From Radiators 300 mm (12”)
From Freezers 25 mm (1”)
5
.
A special receptacle is supplied to
store the mains plug during transit. The
receptacle is fixed at the back of the
cabinet,
on the side of the
compressor
(see diagram). Gently
remove the plug
from the receptacle.
Never pull the mains
cord, you may
damage the appliance. In
the case of
transportation, ensure you
locate the
plug in the receptacle
provided
to
avoid transit damage.
“
IMPORTANT:
Make sure that mains
cable is not caught under the appliance
during and after carrying / moving the
appliance, to avoid the mains cable
becoming cut or damaged.”
Do not allow children to play with the
appliance or tamper with the controls.
Beko
declines to accept any liability
should the instructions not be followed.
Replacing the interior light bulb
To change the Bulb/LED used for
illumination of your refrigerator, call your
Authorised Service. The lamp(s) used in
this appliance is not suitable for
household room illumination. The
intended purpose of this lamp is to
assist the user to place foodstuffs in the
refrigerator in a safe and comfortable
way. The lamps used in this appliance
have to withstand extreme physical
conditions such as temperatures below
-20°C
(only chest and upright freezer)
.
Installation instructions
1. The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.
C
4
. Attach 2 plastic wedges as
illustrated
below. Plastic wedges are
intended to
keep the distance which
will ensure the
air circulation
between your refrigerator
and the
wall. (The picture is drawn up as
a
representation and it is not identical
with your product).
3.
Refer to "Maintenance and
cleaning" section to prepare your
appliance for use.
6
.
The appliance should be
located on a smooth surface. The two
front feet can be adjusted as required.
To ensure that, your appliance is
standing upright adjust the two
front feet by turning clockwise or
anti-clockwise, until the product is in
firm contact with the floor. Correct
adjustment of feet avoids excessive
vibration and noise.
Summary of Contents for LSP1577
Page 1: ...EN Instruction of use Refrigerator LSP1577W ...
Page 2: ......
