Beko HCA62620B, User Manual, Page: 15 / 72

Hood / User Manual
15 / EN
6 Troubleshooting
Symptoms Cause Repairing method
During hood operation, the pulsating
letter „F” is displayed.
After 35 hours of operation the hood
indicates the need for cleaning or
replacing the grease filter.
Press and hold for about 8 sec. “-” on
the touch control. The filter should be
washed in the dishwasher or replace
with a new one.
The display shows only the symbol
“-.” (minus and dot in the right bottom
corner), the hood does not respond
to disabling.
The touch control has been locked
– this feature facilitates the hood
cleaning.
To disable the lock, press and hold for
about 10 sec the field with the symbol
of switching on.
No symbol is shown on the display,
the hood does not respond to pres-
sing the control fields.
The touch control is probably sus-
pended.
Disconnect the hood from the power
supply for about 15 sec. and switch it
on again.
The display shows the symbol of one
of the gears; the hood does not res-
pond to pressing the control fields.
The touch control is probably
suspended
Disconnect the hood from the power
supply for about 15 sec. and switch it
on again.
The hood turbine disconnects after
15 min of operation, the display
shows a pulsating digit i.e. “1.” (cur-
rent gear number and dot in the right
bottom corner).
The automatic time switch of the
touch control has been activated.
To deactivate the time switch, press
and hold for about 10 sec the symbol
„+”or disable the hood.
On fourth gear the digit “4” is pulsa-
ting on the display, after 5min the
gear is changed into third.
The hood is equipped with a turbo
mode, which automatically switches
over into third gear after 5 min of
operation to save energy.
The turbo gear shall be used only with
intensive cooking.
The hood can be operated only with
use of the control panel, it does not
respond to the remote control.
The battery of the remote control is
empty or the distance is too long.
Replace the battery with a new one.
The hood has very poor vapor
suction.
Probably cause is dirty filters. The grease filter must be cleaned in the
dishwasher or replace with a new one.
The carbon filter (if present) must be
replaced with a new one.
One or more light points do not
operate.
Defective halogen/ LED bulb. The light bulb needs to be replaced
with a new, compatible with the symbol
specified in the instruction manual for
the cooker hood.
The hood generated excessive noise
and vibration.
This may be caused by an incorrect
installation of the hood to the wall
or kitchen cabinets. Not all provided
screws have been used or screws are
loosely fitted leaving clearance.
The hood must be mounted to a wall or
cabinet by using all the points provided
for by the manufacturer. After adjusting
the position of the hood horizontally
and vertically, tighten all mounting
screws.
* applies to hoods with touch control.
If the recommendations above do not solve the problem, contact an authorized home appliances service entitled to
repair. Under no circumstances is the hood user entitled to independent repair. A list of service points is included in the
warranty card and the website.