EN
13
1.
Reversing The Door
2.
We recommend that you
reverse the door before switching on
for the first time.
3.
Tools required: Small and
medium size flat and cross-headed
screwdrivers, a pair of pliers. Spare
Parts supplied in the plastic bag: The
following parts, which are exclusively
for left hand side fitted hinge
operation are supplied in a plastic bag
with the appliance:
4.
- Door top trim hinge covers
– there are 2 different parts, one for
each side of top trim.
5.
We suggest you keep all the
parts supplied in the plastic bag and
also parts, which have been removed
when reversing the door, in a safe
place for possible future, re-use.
6.
7.
Important:
We suggest you
ask somebody to help you when
moving the appliance around and to
hold the door when removing / re-
fitting hinges and the door to avoid
any injury and damage to the product.
8.
9.
Please refer to diagrams
supplied. To follow numbers in
brackets below, refer to the main
diagram.
10.
Switch off the appliance at the
socket outlet and pull out the mains
plug.
11.
Remove all loose items and
fittings and food inside the appliance.
12.
Gently prise off plastic hinge
covers on both sides of front top
panel using a small flat-headed
screwdriver. (1-2)
13.
Unscrew the bolts of the top
hinge and remove top hinge. (3)
14.
Remove door carefully off the
bottom hinge and stand door upright
in a safe place.(4)
15.
Gently prise off plastic hinge
cover on door top trim. Fit the other
door top trim plastic off hinge cover
supplied in the plastic bag.(5)
16.
Gently tilt the appliance back
against a strong wall on its rear side
sufficiently to allow the lower hinge
to be removed. Take care to protect
the appliance, your wall and floor
coverings. You can utilise the original
packaging to do this. Once you tilt the
appliance back, check to make sure
the appliance is completely stable and
safe before you carry on. (6)
17.
Unscrew and remove the front
feet and 1 bolt. (7)
18.
Unscrew and remove the
bottom hinge. (8)
19.
Unscrew and remove the
bottom hinge door stopper and
bushing and reposition them on the
other side while rotating
the
bushing 180°. (9)
20.
Fit the bottom hinge and
tighten the screws as shown in figure.
(10)
21.
Fit the other front feet as
shown in figure. (11)
22.
Rotate the top hinge 180°.
Unscrew the hinge pin and re-tighten
it to the opposite side. (12)
23.
Fit the top hinge on the left
hand side bushing of the door. (13)
24.
Locate and re-fit door to
bottom hinge pin. (14)
25.
Re-fit the upper hinge on the
opposite side by using a flat headed
screwdriver. (15)
26.
Fit front top panel plastic hinge
covers on the opposite sides. (16)
