Beko DV 1572 X, User Manual

Page: 23 / 28

23 / 28 EN
Dryer / User Manual
5.11 Child-proof lock
There is a child-proof lock to prevent any programme
interruption due to the pressing of button while the
programme is running. The loading door and all buttons
except the “On/Off” button on the control panel are
deactivated when the child-proof lock is active.
Press the “Start/Pause/Cancel” and “Cancel audio
warning” buttons simultaneously for 3 seconds to
activate the child-press lock.
To start a new programme after the programme is over
or to interrupt the programme, the child-proof lock
should be deactivated. Press the same buttons for 3
sec. again to deactivate the child-proof lock.
C
Child-proof lock is deactivated when the
machine is restarted by pressing the On/
Off button.
Cancel Pres
Start/
Pause
C
Press the relevant buttons for 3 seconds
to activate the child-proof lock. A long
beep will be heard and the child-proof lock
will be activated. A double beep will be
heard if you press any button or turn the
programme selection knob while the child-
proof lock is active. Press the buttons for 3
seconds to deactivate the child-proof lock.
Single beep will be heard and child-proof
lock will be deactivated.
A
A double beep will be heard if you turn
the programme selection knob when the
machine is running and the child-proof lock
is active. If you deactivate the child-proof
lock without returning the programme
selection knob to its previous position, the
programme will be terminated since the
position of the programme selection knob
is changed. The drying light turns on and
the machine remains on hold until a new
programme is selected and the “Start/
Pause/Cancel” button is pressed.
C
Press “Start/Pause/Cancel” button for 3
seconds to cancel the programme or turn
the programme selection knob in any
direction to end the programme while the
machine is running. Water tank and filter
cleaning warning lights turn on to warn the
user when the programme is cancelled by
pressing the “Start/Pause/Cancel” button
for 3 seconds. However, the warning
lights do not turn on when the programme
is cancelled by turning the programme
selection knob. Only the drying light turns
on and the machine remains in hold until
a new programme is selected and the
“Start/Pause/Cancel” button is pressed.
Child-proof lock of the machine should
not be active in order to perform these
two operations. If the child-proof lock is
active, deactivate it before performing these
operations.
Adding/removing laundry in standby mode
In order to add or remove laundry after the programme
starts:
1.Press the “Start/Pause/Cancel” button to switch the
dryer to “Pause” mode. Drying process will stop.
2.Open the door at “Pause” position and close it again
after adding or taking out laundry.
3.Press “Start/Pause/Cancel” button to start the
programme.
C
Any laundry added after the drying process
has started may cause the dried clothes in
the machine intermingle with wet clothes
and the result will be wet laundry after the
drying process is over.
C
Laundry may be added or taken out
as much as desired during a drying
process, but this process will extend the
programme duration and increase energy
consumption since the drying will be
interrupted continuously. Therefore, it is
recommended to add laundry before the
drying programme has started.