Beko DU 7133 PX0, User Manual

Page: 53 / 56

53 / EN
Dryer / User Manual
7 Troubleshooting
Drying process takes too much time.
• Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
• Condenser may be clogged. >>> Clean the Condenser.
• Ventilation grids on the front side of the machine are blocked. >>> Remove the objects
(if any) that block ventilation in front of the ventilation grids.
• Ventilation may not be sufficient since the room where the machine is installed is very
small. >>> Open the door and window of the room to avoid the room temperature
increase too much.
• Lime deposit has built up on the dampness sensor. >>> Clean the dampness sensor.
• Excessive laundry might have been loaded in. >>> Do not load the dryer in excess.
• Laundry might not be spun sufficiently. >>> Spin your laundry at a higher speed in your
washing machine.
Laundry comes out wet at the end of drying.
C
After drying, the hot clothes feel damper than their actual dampness level.
• A programme suitable for the laundry type might have not been used.>>> Check
the garment tag and select a programme suitable for the fabric type or use the timer
programmes additionally.
• Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
• Condenser may be clogged. >>> Clean the Condenser.
• Excessive laundry might have been loaded in. >>> Do not load the dryer in excess.
• Laundry might not be spun sufficiently. >>> Spin your laundry at a higher speed in your
washing machine.
Dryer does not switch on or the programme does not start. Dryer does not start when it is
set.
• It might have not been plugged in. >>> Make sure that the machine is plugged in.
• The loading door is ajar. >>> Make sure that the loading door is closed securely.
• Programme is not selected or the Start / Pause button is not pressed. >>> Make sure
that the programme is selected and the machine is not in Pause mode.
• "Childproof lock" might have been activated. >>> Deactivate the Childproof Lock.
Programme is interrupted without any cause.
• The loading door might not be closed securely. >>> Make sure that the loading door is
closed securely.
• A power failure might have occurred. >>> Press Start / Pause button to start the
program.
• Water tank may be full. >>> Drain the water tank.
Laundry has shrunk, become felted or deteriorated.
• A programme suitable for the laundry type might have not been used. >>> Check the
garment tag and select a programme suitable for the fabric type.
Drum lighting does not turn on. (On models with lamp)
• Dryer might not be switched on with the On / Off / Cancel button. >>> Make sure that
the dryer is switched on.
Bulb may have blown. >>> Call Authorized Service Agent to have the lamp replaced.
Filter Cleaning warning symbol light is on.
• Lint filter is not cleaned. >>> Clean the lint filter.