9
GB
Water inlet hose connection
Make sure your plumbing is suitable
to install your new dishwasher. If in
doubt contact a qualified plumber.
The appliance must be connected
to the water mains using the new
hose set supplied with your new
dishwasher. Old hose sets must
not be re-used.
The water pressure coming from
the water mains supply must be a
minimum of 0.3 and a maximum of 10
bars.
Connect the straight end to your
water mains supply
1
Ensure plastic
filter and black rubber seal is in place.
Please turn on the tap and check for
leakages after connecting the hose.
We recommend the tap is turned off
when the machine is not being used.
If you only have one cold water
feed (For example for your washing
machine) don’t worry, a
Y
adaptor
will provide you with the additional
cold water feed you need for your
dishwasher.
Y
adaptor is available
from most DIY stores.
Drain Hose Connection
Fit the drainage hose of your machine
to the drainage pipe without bending.
Secure your hose firmly to the waste
pipe to avoid it coming off during the
washing process.
The waste pipe must only be
connected into the foul drains and not
surface water drainage system.
The hose should be placed between
50 cm and 110 cm from the floor level
and must not be extended otherwise
the machine may not empty the
waste water.
