Dishwasher / User’s Manual
31 / 41 EN
Operating the product
Adjusting the amount of
rinse aid
1. After turning on the machine,
press Time Delay and P+ keys
simultaneously. After the countdown
(3, 2, 1) is displayed keep the keys
pressed for a while.
2. Press P+ to move to position (P) on the
display.
3. Set to the appropriate level with the
Time Delay key.
4. Press On / Off key to save the setting.
No rinse aid dispensed in P:0 wash position.
1 dose of rinse aid is dispensed in P:1
position.
2 doses of rinse aid are dispensed in P:2
position.
3 doses of rinse aid are dispensed in P:3
position.
4 doses of rinse aid are dispensed in P:4
position.
Rinse Aid indicator ( )
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid indicator
appears on the display of your machine.
End of programme
C
When the programme you have
selected comes to an end, an
audible warning signal will warn
you to turn off your machine.
This audible signal will warn you
with certain intervals before it
turns off.
End of Programme indicator will light up
when the washing programme is over.
1. Open the door of the machine.
2. Press On/Off key to turn off your machine.
3. Close the tap.
4. Unplug the machine from the socket.
C
For energy saving, the machine
is automatically turned off
following the completion of the
programme or if the programme
is not started.
C
Leave your dishes in the
machine for about 15 minutes
to allow them cool down after
they are washed. Your dishes
will dry in a shorter time if you
leave the door of your machine
ajar during this period. This
process will increase the drying
effectiveness of your machine.
Water cut-off warning
If mains water is cut or water inlet tap is turned
off the machine cannot take water in and E:02
icon will flash on the programme indicator.
As long as the problem continues, washing
programme is paused and the water inlet is
checked regularly by the machine; when the
water is restored E:02 icon will disappear after
a while and the washing programme resumes.
Overflowing warning
If the machine intakes too much water or there
is leakage at any of the components then the
machine will detect this and E:01 icon will
flash on the Programme indicator. As long as
the overflowing continues safety algorithm
will be active and try to discharge the water. If
overflowing stops and safety is assured, E:01
icon will disappear. If E:01 does not disappear,
there is a permanent fault. In this case the
authorised service should be contacted.
Summary of Contents for DIS26021
Page 43: ......
