Dishwasher / User’s Manual
15 / 34
EN
Preparation
C
Since different salt brands
in the market have different
particle sizes and since the
water hardness may vary,
dissolution of the salt in water
may take a couple of hours.
Therefore, Salt Indicator
remains on for a while after
adding salt into the machine.
Loose salt grains can cause rust
marks in your machine if not
rinsed away. Only fill salt just
before a programme is run.
Detergent
You can use powder or tablet detergent in
the machine.
C
Only use in the machine
the detergents produced
particularly for use with
dishwashers. We recommend
you not to use detergents that
contain chlorine and phosphate
as they are harmful for the
environment.
C
Contact the detergent producer
if the dishes are wet and/or
if you notice limescale spots
particularly on glasses after the
washing programme is over.
Adding detergent
C
Refer to the “Programme
Table” to determine the correct
amount of detergent for the
selected programme.
A
Do not put solvents into the
detergent dispenser. There is
the risk of explosion!
Put the detergent into the detergent
dispenser just before operating the
machine as illustrated below.
1. Push the latch to right to open the
detergent dispenser lid (A).
2. Put suggested amount of powder or
tablet detergent in the dispenser.
If the hardness level of the water that you
use is above 80 °dF (French standard for
water hardness) or if you are using well
water, then it is recommended to use filter
and water purification devices.
If the hardness level of the water that you
use is below 8°dF (French standard for
water hardness), there is no need to use salt
in your dishwasher. If this is the case, “No
Salt Warning Indicator” (if any) illuminates
continuously on the panel of your machine.
If the water hardness adjustment is set to
level 1, the “No salt warning indicator” will
illuminate continuously although it is not
necessary to use salt. If you use salt under
this condition, salt will not be consumed and
the lamp will not illuminate.
