Dishwasher / User’s Manual
27 / 38
EN
Operating the product
C
Time Delay function cannot be
set after the programme starts.
Starting the programme
To start your machine after selecting the
programme and auxiliary functions, press
Start/Pause/Cancel key.
C
Your machine performs water
softening depending on the
hardness level of the supply
water. Due to water softening
process the programme
duration may change. The
programme duration can also
change while the programme
is running depending on the
ambient temperature where
your machine is installed,
temperature of the supply
water and amount of the
dishes.
C
Pay attention not to open the
door of the machine when it is
running. Stop the machine by
pressing Start/Pause/Cancel
key if you have to open the
door. Then, open the door of
the machine. There may be a
rush of vapour when you open
the door of your machine; be
careful. Close the door of your
machine and press Start/Pause/
Cancel key again. Programme
will resume running.
C
The machine will remain silent
in pause mode for some time
in order to remove the water in
the machine and on the dishes
completely and to have the
water softener cleaned, and
then it will resume running in
drying mode.
Cancelling the programme
1. Press Start/Pause/Cancel key for 3
seconds to cancel the programme.
2. Release the key when the programme
indicator starts flashing. For a couple
of minutes the machine will fulfill
the necessary operations required to
cancel the programme.
C
There might be residues of
detergent or rinse aid in the
machine and/or on the pieces
being washed depending on the
step the programme you have
cancelled was in.
Salt indicator ( )
Please check the salt indicator on the
display to see whether there is adequate
amount of softening salt in the dishwasher
or not. You need to refill the salt reservoir
with salt whenever salt indicator appears
on the display of your machine.
C
Adjusting the water hardness
level is explained in Water
Softening System section.
