27 / 56 EN
Dryer / User Manual
7
Troubleshooting
Drying process takes too much time.
•
Pores of the lint filter are clogged. >>>
Wash the lint filter with warm water.
• Filter drawer is clogged.
>>>
Clean the sponge and the filter cloth in the filter drawer.
• Ventilation grids on the front side of the machine are blocked.
>>>
Remove the objects (if any)
that block ventilation in front of the ventilation grids.
•
Ventilation is not sufficient since the room where the machine is installed is very small. >>>
Open the
door and window of the room to avoid the room temperature increase too much.
•
Lime deposit has built up on the dampness sensor. >>>
Clean the dampness sensor.
•
Excessive laundry is loaded. >>>
Do not load the dryer in excess.
•
Laundry is not spun sufficiently. >>>
Spin your laundry at a higher speed in your washing
machine.
Laundry comes out wet at the end of drying.
C
After drying, the hot clothes feel damper than their actual dampness level.
•
It is likely that the selected programme did not suit the laundry type.>>>
Checking the care labels on
clothes, select appropriate programme for the laundry type or use timer programmes in
addition.
•
Pores of the lint filter are clogged. >>>
Wash the lint filter with warm water.
•
Filter drawer is clogged. >>>
Clean the sponge and the filter cloth in the filter drawer.
•
Excessive laundry is loaded. >>>
Do not load the dryer in excess.
•
Laundry is not spun sufficiently. >>>
Spin your laundry at a higher speed in your washing
machine.
Dryer does not switch on or the programme does not start. Dryer does not start when it is set.
•
It is not plugged in. >>>
Make sure that the machine is plugged in.
•
The loading door is ajar. >>>
Make sure that the loading door is closed securely.
•
Programme is not selected or the Start / Pause / Cancel button is not pressed. >>>
Make sure that the
programme is selected and the machine is not in Pause mode.
•
Childproof Lock is activated. >>>
Deactivate the Childproof Lock.
Programme is interrupted without any cause.
•
Loading door is ajar. >>>
Make sure that the loading door is closed securely.
•
There was a power failure. >>>
Press Start / Pause / Cancel button to start the programme.
•
Water tank is full. >>>
Drain the water tank.
Laundry has shrunk, become felted or deteriorated.
•
A programme suitable for the laundry type is not used. >>>
Check the garment tag and select a
programme suitable for the fabric type.
Drum lighting does not turn on. (On models with lamp)
•
Dryer is not switched on with the On / Off button. >>>
Make sure that the dryer is switched on.
•
Lamp is defective. >>>
Call Authorized Service Agent to have the lamp replaced.
End/Anti-creasing symbol is on.
•
Anti-creasing programme is activated in order to prevent laundry that has remained in the machine from
creasing. >>>
Turn off the dryer and take out the laundry.
