Beko DE 8333 GX0, User Manual

Page: 28 / 60

28 / EN
Dryer / User Manual
7
Troubleshooting
Drying process takes too much time.
• Pores of the lint filter are clogged. >>>
Wash the lint filter with warm water.
• Filter drawer may be blocked;
>>>
clean the foam inside the filter drawer.
• Ventilation grids on the front side of the machine are blocked.
>>>
Remove the
objects (if any) that block ventilation in front of the ventilation grids.
• Ventilation is not sufficient since the room where the machine is installed is very small.
Open the door and window of the room to avoid the room temperature increase too
much.
• Lime deposit has built up on the dampness sensor. >>> Clean the dampness sensor.
• Excessive laundry is loaded. >>> Do not load the dryer in excess.
• Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your
washing machine.
Laundry comes out wet at the end of drying.
C
After drying, the hot clothes feel damper than their actual dampness level.
• It is likely that the selected programme did not suit the laundry type.>>
>Checking the
care labels on clothes, select appropriate programme for the laundry type or use
timer programmes in addition.
• Pores of the lint filter are clogged. >>> Wash the lint filter with warm water.
•
Filter drawer may be blocked;
>>>
clean the foam inside the filter drawer.
• Excessive laundry is loaded. >>> Do not load the dryer in excess.
• Laundry is not spun sufficiently. >>> Spin your laundry at a higher speed in your
washing machine.
Dryer does not switch on or the programme does not start. Dryer does not start when it is
set.
• It is not plugged in. >>> Make sure that the machine is plugged in.
• The loading door is ajar. >>> Make sure that the loading door is closed securely.
• Programme is not selected or the Start / Pause / Cancel button is not pressed. >>>
Make sure that the programme is selected and the machine is not in Pause mode.
• Childproof Lock is activated. >>> Deactivate the Childproof Lock.
Programme is interrupted without any cause.
• Loading door is ajar. >>>
Make sure that the loading door is closed securely.
• There was a power failure. >>> Press Start / Pause / Cancel button to start the
programme.
• Water tank is full. >>> Drain the water tank.
Laundry has shrunk, become felted or deteriorated.
• A programme suitable for the laundry type is not used. >>>
Check the garment tag and
select a programme suitable for the fabric type.