Beko CLEARPOINT M010, Installation & Operation Instructions

Page: 39 / 56

12. If using the BEKOMAT
®
, it must be connected once
again.
For further information, see the attached installation and
operating instructions for the BEKOMAT
®
12. 12.
13. Slowly open the shut-off valves upstream and
downstream of the separator or relevant system
section
9.6 Leak test
The leak test is a non-destructive testing method and is used to prove the leak tightness of vacuum and overpressurized
systems. The leak test can be completed in different ways. BEKO TECHNOLOGIES GMBH does not provide any
recommendations. The operator of the compressed gas system is responsible for selecting the testing process, and
testing should be completed in accordance with applicable standards and directives (e.g. DIN EN 1779).
Installation and operation instructions CLEARPOINT
®
Water separator
39 | 56