Beko CFD6151B, User Manual

Page: 9 / 16

9 / 89 EN
Coffee Maker / User Manual
3 Operation
3.1 Preparation
A
WARNING: First time use: Run the
appliance at least 4 times without
adding coffee.
A
WARNING: Please follow the steps
1 - 2 and 7 - 12 in the “Brewing
Coffee” section.
1. Remove all packaging and stickers and
dispose of them according to applicable legal
regulations.
2. Before using the appliance for the first time,
clean all parts which come into contact with
water carefully. Please see full details in the
“Cleaning and Care” section.
3. Make sure that the appliance is placed in an
upright position and on a stable, flat, clean, dry,
and non-slip surface.
3.2 Brewing Coffee
1. the water tank (6) by holding the moulded
handles at the rear of the tank and lifting
upwards and fill with the required amount of
water, but do not fill past the “10 or 12” mark.
The brewed amount of coffee will be 10% less
than the filled water, because it is absorbed by
the coffee grounds and the filter. For the good
coffee taste it is suggested to operate the
appliance with at least 4 cups coffee serving.
C
Use only clean, cold, and fresh
drinking water.
C
There is a drip hole on the back
of the water reservoir to prevent
exceeding the capacity of the coffee
maker. If you add too much water,
it will drip out from the back of the
appliance.
2. Close the water tank cover (1) and open the
filter basket cover (2).
3. Pull out the filter basket (3).
4. Take a suitable paper filter (1 x 4) and insert the
paper filter into the filter basket (3).
C
Use only one paper filter at each
time. Make sure that the paper filter
does not bend or fold.
5. Fill the filter with the desired amount of ground
coffee. To do this, you may use the supplied
measuring spoon.
6. Insert the filter basket (3) back into the housing.
7. Place the glass jug (8) on the warming plate (9).
A
WARNING: If the filter basket (3)
is not closed or the glass jug (8) is
not placed accurately, the drip-stop
function will not work properly. It
could cause hot water or hot coffee
to overflow.
8. Connect the plug to the wall socket.
9. Turn the appliance on by pushing the On/Off
button (16).
– The On/Off button (16) illuminates and the
brewing process begins.
C
The brewing process can be stopped
at any time by pushing the On/Off
button (16) again.
C
Ventilation slots allow the steam
output. Do not block these during
use.
C
The coffee machine has a stay-
warm function and can keep the
brewed coffee warm for up to
30 minutes when the machine is
switched on. In accordance with eco
design guidelines, the machine will
automatically switch itself off after
this time.