1.
To avoid a hazard due to instability of the appliance, it must be fixed in accordance
with the instructions.
2.
Do not operate this applliance unless installed to furniture.
3.
The appliance should be located on a smooth surface. The four front and back
feet can be adjusted as required. To ensure that, your appliance is standing upright
adjust the four front and back feet by turning clockwise or anti-clockwise, until the
product is in firm contact with the floor. Correct adjustment of feet avoids excessive
vibration and noise.
4.
Refer to "Cleaning and Care" section to prepare your appliance for use.
5
TRANSPORTATION INSTRUCTIONS
1.
The appliance should be transported only in a vertical upright position. The
packing as supplied must be intact during transportation.
2.
If during the course of transport the appliance has to be transported horizontally,
it must only be laid on its left hand side when standing in the front of the
appliance. After bringing it to upright position,it must not be operated for at
least 4 hours to allow the system to settle.
3.
Failure to comply with the above instructions could result in damage occuring
to the appliance. The manufacturer will not be held responsible if these
instructions are disregarded.
4.
The appliance must be protected against rain, moisture and other
atmospheric influences.
5.
When positioning your appliance take care not to damage your flooring,
pipes, wall coverings etc. Do not move the appliance by pulling by the door
or handle.
IMPORTANT :
Care must be taken while cleaning / carrying the appliance to
avoid touching the bottom of the condenser metal support or pipework at the
back of the appliance as you might injure your fingers and hands or damage
your product.
IMPORTANT :
This appliance is not designed for stacking with any other
appliance.
Do not attempt to sit or stand on top of your appliance as it is not designed for
such use. You could injure yourself or damage the appliance.
IMPORTANT :
Make sure that mains cable is not caught under the appliance
during and after carrying / moving the appliance, to avoid the mains cable
becoming cut or damaged.
Do not allow children to play with the appliance or tamper with the controls.
Take care when installing your appliance and using it for the first time, during
normal daily use, while defrosting and cleaning the interior freezer compartments
not to damage cold panels and pipes and to avoid any injury. We recommend the
use of a pair of gloves when cleaning the cold panels as you might injure your
fingers and hands and/or damage the appliance beyond repair.
BEKO plc declines to accept any liability should the instructions not be
followed.
4
IMPORTANT
INSTALLATION INSTRUCTIONS
To avoid any loss in performance, air suction channels should not be obstructed. (140 cm2)
Minimum distance between the wall and the appliance must be at least 10 mm.
10 mm
40 mm
40 mm
10 mm
Wall
Appliance
