31 / EN
Washer-Dryer / User Manual
5.20 End of programme
When the programme is over the End
of Programme indicator illuminates
and a buzzer is heard.
If you do not press any button for 2 minutes,
the machine will switch to standby mode.
Display and all indicators are turned off.
If you press any button or turn the
Programme
Selection
knob when the machine is in
standby mode, programme steps that are
completed will appear on the display.
5.21 Your machine features
a "Standby Mode".
After you switch on your machine with On-
Off button, if no programme is started or no
other procedure is performed at the selection
step or no action is taken within approx. 2
minutes after the selected programme ends,
your machine will switch to energy saving
mode automatically. Also, if your product has
a display that shows programme time, this
display will be completely turned off. If you turn
the Programme Selection knob or touch any
button, lights and display will switch back to
previous condition. The selections which you
make when exiting from the energy efficiency
may change. Please check the correctness of
your selections before starting the programme.
If necessary, please make your settings again.
6 Maintenance and cleaning
Service life of product extends and frequently
experienced problems will be reduced
if it is cleaned at regular intervals.
6.1 Cleaning the detergent drawer
Clean the detergent
drawer at regular
intervals (every 4-5
washing cycles)
as shown below
in order to prevent
accumulation of
powder detergent
in time.
1 Remove the siphon by lifting it from behind
as shown in the picture. After performing
the below mentioned cleaning procedures,
replace the siphon back to its seating
and push its front section downwards to
make sure that the locking tab engages.
C
INFORMATION
• If more than normal amount of water and
softener mixture remains in the softener
compartment, the siphon must be cleaned.
2. Wash the detergent drawer and the siphon
with plenty of lukewarm water in a washbasin.
In order to prevent the residues to contact
your skin, clean it with an appropriate
brush by wearing a pair of gloves.
3 Insert the drawer back into its place after
cleaning and make sure that it is seated well.
6.2 Cleaning the loading
door and the drum
A washer dryer produces combustible lint;
therefore cleaning the door and rubber
gasket after each wash is important.
Use a soft damp cloth to wipe the door,
cleaning any water marks or residue off it.
Wipe the rubber seal around the door. Remove
any items or lint accumulating in the bottom
of the seal catchment and wipe out any
water accumulated here. If this is not cleaned
out, unpleasant odours can also develop.
For products with drum cleaning
programme, please see Operating
the product - Programmes.
