Beko BRVPF 090, User Manual

Page: 21 / 52

Splıt-type room air conditioner / User Manual
21 / 52 EN
5.2 Troubleshooting
When troubles occur, please check the following points before contacting a repair company.
Problem Possible Causes Solution
Poor Cooling
Performance
Temperature setting may be higher
than ambient room temperature
Lower the temperature setting
The heat exchanger on the indoor
or outdoor unit is dirty
Clean the affected heat exchanger
The air filter is dirty
Remove the filter and clean it
according to instructions
The air inlet or outlet of either unit
is blocked
Turn the unit off, remove the
obstruction and turn it back on
Doors and windows are open
Make sure that all doors and
windows are closed while operating
the unit
Excessive heat is generated by
sunlight
Close windows and curtains during
periods of high heat or bright
sunshine
Too many sources of heat in
the room (people, computers,
electronics, etc.)
Reduce amount of heat sources
Low refrigerant due to leak or long-
term use
Check for leaks, re-seal if necessary
and top off refrigerant
SILENCE function is
activated(optional function)
SILENCE function can lower product
performance by reducing operating
frequency. Turn off SILENCE
function.
The unit is not
working
Power failure Wait for the power to be restored
The power is turned off Turn on the power
The fuse is burned out Replace the fuse
Remote control batteries are dead Replace batteries
The Unit's 3-minute protection has
been activated
Wait three minutes after restarting
the unit
Timer is activated Turn timer off
5 Troubleshooting