Beko BEKOMAT 8, Installation And Operating Manual

Page: 15 / 28

EN
Installation and operating manual
BEKOMAT
®
8/9 15
3.2. Installation
The diagrams below show examples of BEKOMAT
®
8/9 installation options.
NOTICE Installation instructions
• Install a separate BEKOMAT
®
at each point where condensate might be produced.
• Do not use cone-shaped fittings.
• Keep the pipes as short as possible.
•
Do not install filters/dirt traps in the condensate inlet.
• Only install ball valves in the condensate inlet line.
• The venting line must be installed above the highest possible condensate level.
• Observe the minimum installation heights.
Installation of BEKOMAT
®
8/9
Venting line A:
Lines ≥ ¾" must be equipped with ball valve
Condensate inlet B:
Pipes ≥ 2" (DN 50) must be installed with flange and ball
valve:
•
short inlet pipe!
• Condensate inlet slope >1%!
• No filter in condensate inlet!
Condensate discharge C:
Install pipe ≥1"
(for BEKOMAT
®
9: ≥ 2"):
• Do not feed to a manifold!
• Max. incline 5 m!
• If the pipe is installed at an incline, the minimum
operating pressure is increased by 0.1 bar per metre!
For maintenance:
Manual drain D:
• Lines ≥ ¾" must be equipped with ball valve
Bypass line E:
• Lines ≥ 1" must be equipped with ball valve
B
A
C
D
E