Beko 9320, User Manual

Page: 10 / 24

10 / 21 EN
Vacuum Cleaner / User Manual
4 Cleaning and maintenance
Before cleaning, press the on/off switch (11) to
switch the product off and unplug (26).
A
WARNING:
Never use gasoline,
solvent, abrasive cleaning agents,
metal objects or hard brushes to
clean the appliance.
4.1 Draining and cleaning the water
tank
1- After releasing the water tank locking latch (9)
lift the dust container lid upwards.
2. Remove the water tank holding it from its
handles.
3. Pull the filter unit out of the water tank (24)
holding its handle.
4. Drain the used water from water tank (24) and
flush with clean water.
5. Remove the air guiding part (16) from the water
tank and clean.
6. Hold the handle of the filter carrier located on
the filter unit and remove turning in the arrow
direction.
7. After removing the filter carrier, separate
cyclonic filter (17) and cyclonic filter cover (18)
rotating in the arrow direction.
8. Clean and rinse the cyclone, cyclone cover and
water diffusing separator of the filter unit with
clean water.
9. After cleaning, install the parts following the
above steps in reverse order.
4.2 Air Outlet Filter
1. Open the air outlet filter cartridge located on the
rear side of the product pressing the release
switch.
2. The filter and the black filter in the back that will
become apparent after opening the cartridge,
should be washed cleaned once in every 3
months or when required.
A
WARNING:Do not use appliances
producing hot air such as hair
dryer or heater to dry the filters.
A
WARNING:
Do not install the filters
without completely drying them;
otherwise smell of moisture may
occur during the use, water can leak
from the back of the appliance or the
filters may get damaged.