Beko 7178543900, User Manual

Page: 39 / 48

EN / 39
h. After the completion of the washing pro-
cess, the cover is inserted to the drawer.
Make sure that all guides are in place. If
the guides do not fit, liquid may spill from
the drawer, or the detergent box may get
trapped in the drawer rail or move in diffi-
culty. Therefore, make sure that the
guides are firmly seated.
i. Insert the drain stick back into its slot in
the back of the drawer.
j. Refit the drawer by paying attention to its
slot and slides and push the drawer to
close. Once detergents and softeners are
added, they will be ready for use in dosed
programs.
7.2 Cleaning the Loading Door and
the Drum
For products with drum cleaning pro-
gramme, please see the Operating the
product section.
Repeat Drum Cleaning process in
every 2 months.
NOTICE: Use an anti-limescale suit-
able for the washing machines.
After every washing make sure that no for-
eign substance is left in the product.
If the holes on the door gasket shown in the
figure is blocked, open the holes using a
toothpick.
Foreign metal substances will cause rust
stains in the drum. Clean the stains on the
drum surface by using cleaning agents for
stainless steel.
Never use steel wool or wire wool. These will
damage the painted, chrome coated and
plastic surfaces.
We recommend you to wipe the door gasket
with a dry and clean cloth at the end of the
programme. This will remove residues on the
door gasket in your machine and prevent
formation of malodours.
7.3 Cleaning the Body and Control
Panel
Wipe the body of the product with soapy
water or non-corrosive mild gel detergents
as necessary, and dry with a soft cloth.
Use only a soft and damp cloth to clean the
control panel. Do not use cleaning products
that contain bleach
7.4 Cleaning the Water Intake Fil-
ters
There is a filter at the end of each water in-
take valve at the rear of the product and also
at the end of each water intake hose where
they are connected to the tap. These filters
prevent foreign substances and dirt in the
water to enter the product. Filters should be
cleaned if they are dirty.
a. Close the taps.
b. Remove the nuts of the water intake
hoses to access the filters on the water
intake valves and clean them with an ap-
propriate brush. If the filters are too dirty,
remove them from their places with a pli-
ers and clean in this way.
c. Take out the filters on the flat ends of the
water intake hoses together with the gas-
kets and clean thoroughly under running
water.
d. Replace the gaskets and filters carefully
and tighten their nuts by hand.