Beko 7145846400, User Manual

Page: 20 / 60

20 / EN
Washing Machine / User Manual
Adding or taking out laundry
You can load/unload laundry when a programme is running if the water level is appropriate to open
the door. To do this:
1. Press Start / Pause button to switch the machine to pause mode. The programme follow-up light
of the relevant step during which the machine was switched into the pause mode will flash.
2. Wait until the Loading Door can be opened.
3. Open the Loading Door and add or take out the laundry.
4. Close the Loading Door.
5. Make changes in speed settings, if necessary.
6. Press Start / Pause button to start the machine.
4.3.15 Cancelling the programme
To cancel the programme, turn the Programme Selection knob to select another programme.
Previous programme will be cancelled. End / Cancel light will flash continuously to notify that the
programme has been canceled.
Your machine will end the programme when you turn the Programme Selection knob; however, it
does not drain the water inside. When you select and start a new programme, the newly selected
programme will start depending on the step the previous programme was canceled in. For example,
it may take in additional water or continue to wash with the water inside.
C
Some programmes may start by discharging the water inside the machine. Depending on the step where the
programme was canceled in, you may have to put detergent and softener again for the programme you have
selected anew.
4.3.16 End of programme
When the programme ends, "End" LED becomes on at the Programme Follow-up indicator.
1. Wait until the "Door Lock Enabled LED" goes off completely.
2. To switch off the machine, turn the Programme Selection Knob to On/Off position.
3. Take out your laundry and close the loading door. Your machine is ready for the next washing
cycle.
4.3.17 Your machine features "Pause Mode".
After you switch on your machine with the programme selection button (by switching the button
to a different position than the On/Off position), if no programme is started or no other procedure
is performed in the selection step or no action is taken within approx. 2 minutes after the selected
programme ends, your machine will switch to energy saving mode automatically. The brightness of
the indicator lights will decrease. Also, if your product has a display that shows programme time, this
display will be completely turned off. If you turn the Programme Selection knob or touch any button,
lights and display will switch back to previous condition. The selections which you make when exiting
from the energy efficiency may change. Please check the correctness of your selections before
starting the programme. If necessary, please make your settings again. This is not an error.