E.)
Things to be checked at fully-automatic position
1.
Hydraulic operations should not be working when the machine is at stop or auto mode.
2.
After obtaining the main operating conditions of the machine (tape, cover, emergency stop) at auto mode the machine should
not have ‘no material’ warning signal.
3.
You should write part quantity requirements to the counter
4.
İf there is not material but the machine is turned on at auto mode, the machine should indicate no material warning signal.
5.
The machine should not start up when there is material but it is not clamped;
a.
Automatically the blade must go to the upper point switch.
b.
Vices should close automatically.
c.
Machine should detect firstly the vice swich and then the pressure swich.
d.
Wait a while for the detection of the pressure switch. (1-2 sec)
e.
After this time the material shoul automatically be fed forward.
f.
İf sensor signal is cut during the feeding, the process should stop at that time.
g.
The saw must lift up to the height of material.
h.
This process should be repeated again, if there is interruption of the sensor signal .
i.
Feeding material should go on to the gauge swich.
j.
After feeding the material there should be fast approach.
k.
With sensor signal stop, the machine should get to the speed that operator adjusted and if it is selected coolant flow should
start.
l.
Cutting should keep on till the lower swich point continuously.
m.
When the material is cut and lower signal is received , the feeding vice rolls take back the material as the adjusted time
and then the blade goes up.
n.
After taking back the material, the blade should go up to the top point.
o.
When blade moving above is finished, the machine should inform the counter that cutting is finished and should increase
the value of the counter 1pc.
p.
Then feeding should start again and opter operations should go on.
q.
All of this should continue until the number of cuts mentioned on the counter..