BeingHD TOUCH MANAGER Series, User Manual

Page: 3 / 25

3
To protect the device and operating personnel from electrostatic
discharge, you need to check and ensure that the device is grounding
well before the device is powered on. Please observe the following
when you install, use, maintain this equipment.
Attention the equipment needs good earth grounded
➢ Please use single-phase three wire system AC 220V power supply, and
ensure all transmission system is grounding well.
➢ To protect operating personnel and the device ， please turn off all power
supplies and pull the plug before moving the device or doing some specific
works which need to be done when the electricity is turned off . Please turn
off the main power switch on rainy days or when not in use for a long time.
➢ Please do not put anything upon the cables, or tread the cables.
➢ To avoid damaging the device, please turn off power supply before plugging
cable into the device or pulling cable from device. The damage caused by
plugging/ pulling cables without turning off power supply is outside the
scope of the warranty.
➢ The power of the device gives out heat when it works, so it ’ s necessary to
keep the work environment ventilated to protect the device from the
damage caused by over temperature.
➢ Do not place the device in very cold or very hot places. Do not sprinkle any
corrosive chemicals or liquid on or around the device.
➢ To avoid accident or any further damage ,non-professionals please do not
dismantle or maintain the device without permission.
SAFETY