Page 4
The position of the probe is a crucial factor for a gas detection unit correct functioning.
In order to obtain the maximum results from an appliance and minimize the probabilities of false alarms, we recommend
to follow this diagram and to keep in mind the following general rules.
The remote probe must be located at different heights, according to the type of gas.
These heights are:
- 30 cm from the lowest point of the floor in order to detect
heavy gases (L.P.G. etc.)
- 30 cm from the highest point of the ceiling in order to detect
light gases (Methane, etc.)
The probe should not be placed near the appliances to be controlled (boilers, burners, industrial kitchens, etc.) but
on the opposite wall.
The probe should not be affected by smoke, vapour, etc. as they could distort their measurement. It must be placed
away from sources of heat, suction fans, ventilation fans.
30 cm.
Light Gases
30 cm.
Heavy Gases
Positioning of the Probe
Detection Diagrams Data
0 4% 8% 12% 16% 20%
0
4
5
1
0
15
2
0
7,2
10,4
13,6
16,8
20
mA
L E L
Fault Zone
Linear +/-5%
Explosive Detection Diagram
ppm
0 50 100 150 200 250 300
6,7
0
4
5
10
15
2
0
7,2
20
m A
9,3
12
14,6
17,3
Linear +/-5%
Fault Zone
Diagram of Toxic Gas Detection
N O N
!
N O N
!
YES
