Page 7
If the device does not start up.
Check that the 230V power is correctly connected.
If the fault LED lights up.
Check the CO922 detection capsule status. They may faulty or to have exhausted after 5/6
years must be replaced.
If the detector is repeatedly issuing an alarm..
1) Check that there are no gas leaks.
2)Check that there is not a persistent low concentration of CO, Check! see table on page 4
Make sure that together with the alarm it does not turn on even the FAULT led.,in this case proceed to the
control of the sensors.
If the detector is issuing an alarm and does not shut off the devices connected to it.
Check that the wiring is correct and that the jumper that carries power to the relay has been set properly
We advise that all relays are tension free.
Check the drawing of the connections.
If the CO922 is connected to a solenoid valve 12VDC and is not operate
The CO922 can not be connected directly to solenoid valves, sirens to 12 VDC
An external power supply must always be used.
Do not tamper the detector.
Not to cause the decalibration of the device, and electric shock.
Before calling a technician check ...
The installation of the detector does not exempt...... from the compliance with all regulations concerning the characteristics,
installation and use of gas appliances, the ventilation of the spaces and the elimination of combustion products are described
in the UNI norms according to ART. 3 LAW 1083 / 71 and relevant legal provisions.
1) Put out all free flames.
2) Close the main gas tap or the LPG cylinder tap.
3) Do not turn any lights on or off; do not turn on any electrical device or appliance.
4) Open windows and doors in order to increase ventilation.
If the alarm stops, its cause must be found and the relevant consequent measures taken.
If the alarm continues and the cause of gas presence cannot be found or removed, abandon the building and call
the emergency services when outside (fire department, distributors, etc.)
Warning !!
If you have the following symptoms: vomiting, sleepiness, or else, go to the closest first aid station and inform the
operators that you could have been poisoned by Carbon Monoxide.
If other problems arise, a specialised and/or authorised technician and/or the Distributor of BEINAT S.r.l.
should be contacted directly.
WARNING! Actions to be taken in case of alarm
ppm
Symptoms of Carbon Monoxide
“CO” poisoning
150 HEADACHE within 2 hours
250 HEADACHE within 3 hours
450 STRONG HEADACHE
800 CONVULSIONS within 30 minutes
1500
DEATH within 2 hours
5000
DEATH within 20 minutes
