9
We recommend starting with low level first then increasing gradually!!
C. Operation procedure
1) Make sure power cord is securely connected, and fuse is equipped in right position on main
body.
2) Turn power
‘
on
’
position, then power switch on front side of main unit will be activated.
3) Make sure grounding bar and foot switch are properly connected.
4) Initial screen will be displayed as following upon key switch on, and stand-by screen will be
shown after 2 ~3 seconds.
< Initial Screen >
Micro Needl RF Mode
5) Select ‘micro needle RF mode’, and then you can find screen like below picture.
