Installation
8
Beijer Electronics
2
Installation
This chapter describes how to mount the expansion card in the operator
terminal.
2.1
Installation of one expansion card
Perform the following steps to mount an IFC PBDP expansion card:
1. Switch the terminal power off.
2. Make sure that the ESD protection is good.
3. Remove the cover plate on the rear of the terminal, and the two expansion
plates on the short side. In terminals equipped with two expansion slots, the
slots are called
Slot 1
and
Slot 2
. In terminals with only one expansion slot,
it is called
Slot 1
.
Slot 1
Slot 2
