Hardware
Beijer Electronics, MA00757A
39
3.7.9 Replacing the Backlight
To following is needed:
– A new backlight, see the
list.
– A torx T10 screwdriver
– A screwdriver Phillips size 0 or 00 (only for EXTER T150).
EXTER K30m, EXTER K60c, EXTER T40/T40m, EXTER T60c/T60m and
EXTER K70/T70
If the backlight is broken on a terminal above, the entire display must be replaced.
To replace the display you will need a new display including plastic frame and display
cable, see the
section. For information on how to change the
display See
Replacing the Display/Display Cable
EXTER T100
To replace the backlight of EXTER T100, follow the steps 1-5 in section
for EXTER T100. Then follow the steps below:
1. Gently move the backlight diagonally in direction from the display center to
release the snap-in closure that keeps the backlight in place.
2. Remove the backlight from the display.
3. Insert the new backlight. Be careful not to pull the cables of the new backlight
when inserting it, since pulling the cables will damage the backlight.
4. Re-assemble the complete operator terminal.
Note:
All lamps in the display must be replaced at the same time.
Note:
Make sure you have adequate ESD protection.
backlight snap lock
backlight
connectors
